iMate SP3 PDA / Mobile Phone Holder

An active mobile phone holder with a straight cable with open end for fixed installation and a cable with Molex adapter system. The cables are to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior.

You can choose to use the holder as an active holder only for charging, or to connect an adapter to the Molex connector for additional features. Then you can use the holder also for power supply of a GPS receiver, data transfer or other own solutions.

12/24 Volt. The product is E-approved. Connect the power cable with a 1,5 A fuse. 2 A charger. Professional installation recommended. The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection.

More Details »

Versions available:

i-Mate mobile phone holder - 971959 i-Mate

If you require a no holes car mounting bracket they are listed under your vehicles manufacturer in the vehicle specific products list. Click here to take you there.

i-Mate mobile phone holder - 971959 i-Mate

If you require a no holes car mounting bracket they are listed under your vehicles manufacturer in the vehicle specific products list. Click here to take you there.

i-Mate mobile phone holder - 971959 i-Mate

If you require a no holes car mounting bracket they are listed under your vehicles manufacturer in the vehicle specific products list. Click here to take you there.